Cleaning Steps And Operation Of Colloid Mill

Colloid mill needs to be cleaned after use. Not all materials can be cleaned by simple flushing. Some materials are very troublesome to clean. Incomplete cleaning will seriously affect the service life in the later stage. The following editor will introduce the details of cleaning and operation of colloid mill.
1. Cleaning steps of colloid mill
1. When the colloid mill is stopped, shut down and cut off all power supplies, and then rinse the residual materials in the machine with clean water.
2. Disassemble the hopper, discharge pipe, discharge nozzle, rotating teeth, fixed teeth and gap adjustment sleeve in turn and clean them.
3. It is recommended to use other small tools, such as brushes or tweezers, to better clean the waste residues in the tooth gap and groove, and then rinse them with clean water.

4. For detachable parts, it is recommended to clean the surface of the parts with a cleaning agent, pay special attention to the cleaning of the gaps, rinse with clean water, and dry naturally.
5. For parts that cannot be disassembled, first use clean water to flush away the waste residue in the grinding seat groove, then use a brush dipped in detergent to scrub the grinding seat groove and rinse it clean.
6. After scrubbing the outer surface of the main body with detergent, wipe it with a clean wet cloth to remove the residual detergent on the outer surface, and then wipe it again with a dry cloth.