How To Confirm That The Meat Roll Machine Can Be Used Normally?
May 30, 2025| After installing the new blade, a test is required to ensure the normal operation and cutting quality of the equipment. The specific steps are as follows:
1. Power on the equipment and start it, and observe the operation of the new blade. If any abnormal situation is found, such as blade swinging, excessive noise, etc., it is necessary to stop the machine immediately for inspection and treatment.
2. Use mutton for test cutting and observe the cutting effect and meat quality. If problems such as uneven cutting and damaged meat are found, the blade needs to be adjusted or replaced.
| Model | Power | Size (length*height*width) |
| single roll | 750W | 660*720*380(cm) |
| CNC single roll | 1500W | 1100*930*400(cm) |
| Double roll | 2500W | 1400*1300*450(cm) |
| Double roll reinforced model | 3000W | 1450*1400*550(cm) |
| Four roll | 3000W | 1500*1400*700(cm) |
| Six roll | 3000W (380V) | 1600*1400*850(cm) |
| Eight roll | 5500W (380V) | 1700*1450*1150(cm) |
3. If the test effect is good, it can be officially put into use. During use, it is necessary to regularly check the wear of the blade and the operation of the equipment, and perform maintenance and maintenance in time.
Through the detailed introduction of the above steps, I believe that readers have a deeper understanding of the operation of replacing the blade of the CNC mutton cutting and rolling machine. In actual operation, it is necessary to pay attention to safety issues and follow the equipment's instruction manual and the manufacturer's guidance and suggestions. At the same time, regular maintenance and maintenance of equipment is also one of the key measures to extend the service life and improve the cutting effect.