Potato Chip Production Line
Model
LYS-65 LYS-70 LYS-85 LYS-95
Power
5.5kw 15kw 18.5kw 22kw
Capacity
50 kg/h 150kg/h 200-300kg/h 400-500kg/h
- Product Introduction
Product Introduction
During the production process, the extruder is easily contaminated by granular food, which may cause equipment failure over time. Therefore, it is necessary to clean the extruder regularly. When cleaning, the parts of the equipment should be removed first to remove the granular food residues on the surface. Then clean it with clean water, detergent, etc., and check the various parts of the equipment to ensure that there is no blockage or defect. After cleaning, anti-rust and anti-corrosion treatment should be carried out before assembly to avoid the occurrence of extruder failure.
Product Parameters
| Model | Power | Capacity | Heater | Dimension(mm) | Weight |
| LYS-65 | 5.5kw | 50 kg/h | 1 kw | 1720*870*1050 | 350 kg |
| LYS-70 | 15kw | 150kg/h | 1 kw | 1720*970*1250 | 500 kg |
| LYS-85 | 18.5kw | 200-300kg/h | 2 kw | 1360*1870*850 | 650 kg |
| LYS-95 | 22kw | 400-500kg/h | 2 kw | 2300*1170*1400 | 850 kg |
If the extruder is not lubricated for a long time, the friction between the various parts of the equipment will cause excessive heat, thus reducing the service life of the equipment. Therefore, during use, the equipment should be lubricated regularly according to the frequency of use of the equipment to maintain its normal operation. When lubricating, appropriate lubricants should be selected and the application and cleaning steps should be carried out according to the instructions. For the box bearings, the lubricating grease should be replaced once after 500 hours of operation. Other bearing parts should also be regularly filled with grease.
It is strictly forbidden to use hard objects and heavy hammers to disassemble and assemble the extruder's screw, screw sleeve and other wearing parts. It is strictly forbidden to place heavy objects or stand on the extruder chamber. Check the quality of the extruder at any time and pay attention to the replacement of wearing parts. Since the wearing parts near the discharge port wear relatively quickly, the wearing parts near the feed port wear less, so when replacing wearing parts, they should be replaced in sequence starting from the discharge end, and it is not advisable to replace multiple parts at one time.
Our Advantages
150
+
Number Of Employees
3000㎡+
Factory Area
10
+
Years Of Experience
800㎡+
Company Area
Qualifications and Honors
Hot Tags: potato chip production line, China potato chip production line manufacturers, factory, event for food puffing industry, barley for food puffing, food puffing distribution, blue colorant for food puffing, workshop on food puffing, vertical form fill seal packaging machine for food puffing
