Machine To Cut Meat
Model
200 400 800
Voltage
220v/380v
Rolls
2 4 8
Capacity
50-200kg/H 150-300kg/H 50-600kg/H
Slice speed
50-60/m
- Product Introduction
Product Introduction
Commercial frozen meat slicers may encounter a variety of faults in daily use. The following are some common fault analyses:
1. Irregular tripping or leakage:
Possible cause: Poor insulation of the motor coil leads to leakage. The motor coil needs to be checked and possibly replaced to ensure that the insulation strength between the motor and the housing meets safety standards.
2. Abnormal noise:
Check points: Whether the machine bolts are loose, whether the moving parts of the machine such as the bearings lack lubricating oil, and whether there is minced meat residue around the blade that causes the blade to be unbalanced.
Product Parameters
| Model | 200 | 400 | 800 |
| Weight | 200kg | 350kg | 600kg |
| Slice thickness | 0.3-5mm | 0.3-5mm | 0.3-5mm |
| Width (custom-made) | 270mm | 510mm | 900mm |
3. Vibration or slight noise:
Check whether the workbench is stable, whether the machine is placed stably, and make sure that all fixed parts are properly installed and tightened.
4. The grinding wheel cannot sharpen normally:
Maintenance measures: Clean the surface of the grinding wheel to ensure a smooth sharpening process.
5. Slicing is weak or the machine does not run:
Check whether the drive belt is worn, oiled or broken, whether the capacitor is aged, whether the circuit plug is in good contact, and whether the fuse is blown.
6. The machine body is electrified:
Safety measures: Cut off the power immediately and check whether the grounding system is normal. If necessary, ask professional electrical personnel to handle it.
7. Cannot cut the ideal meat roll:
Cause analysis: The temperature of the frozen meat may not be low enough. It is recommended to ensure that the meat is within the range of 0~-7 and fully frozen before slicing.
8. The blade slicing effect is not good:
Check whether the blade is sharp. The wear of the blade will affect the quality of slicing. Sharpen or replace the blade if necessary.
9. The machine is weak:
In addition to checking the transmission belt and capacitor, it is also necessary to confirm whether there are other mechanical parts that are damaged or worn, such as gears, bearings, etc.
Our Advantages
150
+
Number Of Employees
3000㎡+
Factory Area
10
+
Years Of Experience
800㎡+
Company Area
Qualifications and Honors
Hot Tags: machine to cut meat, China machine to cut meat manufacturers, factory, slicer for kitchen meat roll cutting, device for slicing meat roll for catering use, durable slicer for meat rolls, cutter for cutting meat roll in supermarket, device for slicing meat roll for catering food service, cutter for meat rolls
